USB2.0 Type-C接口接线图，usb转typec接线方法

1、Pin A5 (CC) of the USB Type-C plug shall be connected to VBUS through a resistor Rp (56 k? ± 5%).
See Section 4.5.3.2.2 and Table 4-24 for the functional description and value of Rp.

2、Contacts B6 and B7 should not be present in the USB Type-C plug.

3、All VBUS pins shall be connected together within the USB Type-C plug. Bypass capacitors are not
required for the VBUS pins in this cable.

4、All Ground return pins shall be connected together within the USB Type -C plug.

5、Shield and GND grounds shall be connected within the USB Type -C and USB 2.0 Standard-A plugs on
both ends of the cable assembly.

6、All USB Type-C plug pins that are not listed in this table shall be open (not connected)

翻译：

1、USB Type-C插头的引脚A5（CC）应通过电阻器Rp（56 k? ± 5%).Rp的功能描述和值见第4.5.3.2.2节和表4-24。

2、USB Type-C插头中不应存在触点B6和B7。

3、所有VBUS引脚应在USB Type-C插头内连接在一起。旁路电容器不是此电缆中的VBUS引脚需要。

4、所有接地返回引脚应在USB C型插头内连接在一起。

5、屏蔽和GND接地应连接在USB类型-C和USB 2.0标准-A插头内电缆组件的两端。

6、本表中未列出的所有USB Type-C插头引脚均应打开（未连接）